Model Tech P-47 Thunderbolt Specifikace stáhnout pdf (Strana 10)

Need help or have any questions? Call us at 1-714-963-0329 or send us an Email at service@globalhobby.net

❑ Using a modeling knife, cut away and remove the

excess covering material that overlaps onto the root ribs

of each wing panel, leaving about 1/16" overlapped so it

does not pull away.

IMPORTANT

It's very important to the integrity of the wing center section

joint that you remove as much covering from the root ribs as

possible.

❑ Use a ruler and a pencil to locate and draw a vertical

centerline on each side of the plywood dihedral brace.

❑ Test-fit the dihedral brace into each wing panel. It should

slide into each panel up to the centerline you drew.

☞

If it does not fit properly, use 220 grit sandpaper with a

sanding block to lightly sand the edges and tips of the brace.

WARNING

The dihedral brace is cut in the shape of a "V". The "V"

shape should face the top surface of the wing when the brace

is installed.

❑ Slide both wing panels together with the dihedral brace

temporarily installed (without using glue).

☞

Notice the hardwood dowel in one wing panel engages

the predrilled hole in the opposite wing panel.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 67 68

Žádné komentáře

Model Tech P-47 Thunderbolt Specifikace Strana 10